Features
Wall lining System in Nepal is an innovative and the fastest way to refurbish existing walls. It can save a potential amount of fortune as compared to traditional methods. It can be used only as an interior wall lining material which can be installed on concrete or masonry walls, reducing masonry work for speedy installation at low cost with minimum wet work.. Wall lining consists of two System in Nepal:
Independent metal frame System in Nepal: The independent framework enables wall lining to be used over all types of back ground, this System in Nepal consists of fixing light weight galvanized metal frame on the masonry/block walls with Gypsum Board screw fixed and joint finished.
Adhesive dabs System in Nepal: The System in Nepal uses the principle of gypsum adhesive dabs to bond Gypsum Boards directly to the masonry walls, giving nice appearance and crack free surface. This System in Nepal is unsuitable for area subject to continuously damp or humid conditions.
These System in Nepal can be used in all types of building in both new build and refurbishment work. It can take various different forms and textures depending on use; it allows easy decoration by either painting or wallpaper.
Application
All commercial and residential projects, such as: Model apartments, department stores, hospitals, office building, house building material Nepals, restaurants, industrial factories and refurbishment work.
Independent Metal Frame System in Nepal
Steps
- Determine cavity depth required and mark lines to floor and ceiling to indicate positioning perimeter channel.
- Fix expansion bolt 6mm to perimeter channel, at 60cm center.
- Mark lines on the wall at 60cm intervals to indicate fixing bracket center.
- Mark horizontal lines at 80cm center to indicate fixing bracket position.
- Fix bracket with expansion bolt 6mm.
- Cut channel section to the height of lining.
- Friction fit channel into perimeter channel and set inside 2 legs of bracket.
- Fix 12mm thickness HOMEMANDU Gypsum Boards to all framing members at 30cm center using drywall screws.
- Finish board joints, with joint taping hide screw heads with HOMEMANDU GypCompound and leave it for 24 hours for drying.
- Grind the exposed compound with abrasive paper.
- Ready for Painting or pasting wall papers.
Adhesive Dabs System in Nepal
Steps
- Determine the highest spots on the wall and plumb position to the ceiling and floor.
- Transfer this dimension to the room corners. Mark all with vertical lines at 1.22m interval.
- Mix drywall adhesive with clean water accordingly.
- Apply a continuous fillet of adhesive to the perimeter of the wall through the vertical lines. From dabs 50mm to 80mm wide and about 250mm long.
- Positions dabs of adhesive in three vertical rows. Apply six dabs a row before placing the first board.
- Position the board, ivory face against the dabs, with the bottom edge resting on a small piece of Gypsum Board.
- Tap the board back firmly using a straightedge until it aligns with the ceiling and floor lines.
- Finish board joints, with joint taping hide screw heads with HOMEMANDU GypCompound and leave it for 24 hours for drying.
- Grind the exposed compound with abrasive paper.
- Ready for Painting or pasting wall papers.
- Suspended Ceiling System in Nepal
- Dry Wall Partition System in Nepal
- Wall Lining System in Nepal
- Wall System in Nepal Enhancement
- Grid Ceiling System in Nepal (T-Bar)
- Gypsum Plaster Application System in Nepal
- Gypsum Jointing Compound Application System in Nepal